F16C Base / Crown Molding, 16"W

Base/Crown & molding 16"

1"h x 16"w

The base and crown are each 1" high.

The base & crown is designed to fit the rack length exactly, so depending on your racking order, you can choose the exact length of finish molding.

The base are designed to fit the depth of the racking, the base will be offset from the wall at the back, to mirror the racks above.

Add 2" to your racking layout height if you want to put one section on the top and one section on the bottom.

The base kits are faced with redwood. The platform is 1" black melamine to be placed directly on the ground.

While the manufacturer, doesn’t state anything, we suggest placing a sheet of plastic on top of the floor where the base is to go to act as a moisture barrier.

The height of the face molding is 1 3/16”, adjusted to match the base, cover any shims under the base if needed, and overlap the racking.

Once the racks are installed you can't really see through to the melamine and further to that, once you bottles are in place, you definitely can't see through. Unless you want a base that is higher, you can't build a better base for less than our cost.

Please keep in mind that base and crown are not necessary.

Your racks can sit right on the ground or you can build your own base using a larger baseboard and crown moulding.

The base provides a more finished look to your racks and allows an area to shim for any floor unevenness.